I want to conversion the ip address of hp 3600 printer manually . how can i do it
Answers:
I tried to copy this as best I could but they use some special characters in the explanation. The address for the full manual is
http://h20000.www2.hp.com/bc/docs/suppor...
And this comes from the heading of grating configuration
Setting an IP address
1. Press Menu.
2. Press down to underscore CONFIGURE DEVICE, and later press check flaw.
3. Press down to underscore I/O, and later press check put pen to paper.
4. Press down to underline EMBEDDED JETDIRECT, and consequently press check flaw.
5. Press down to put emphasis on TCP/IP, and later press check stain .
6. Press check sitting duck to select CONFIG METHOD.
7. Press down to underline MANUAL, and consequently press check fault.
8. Press down to call attention to MANUAL SETTINGS, and consequently press check sucker.
9. Press down to stress IP Address:, and consequently press check flaw.
10. Press the up or down arrow to increase or terminate the number for the first byte of the IP address.
11. Press check splodge to move to the subsequent set of numbers. (Press hindmost arrow to move to the previous set of numbers.)
NOTE To cycle through the numbers faster, hold down the arrow button.
12. Repeat steps 10 and 11 until the correct IP address is enter, and consequently press check imperfection to recover the
setting.
13. Press Menu to return to the Ready state.